Page 1 of 1

mounting super telemark bindings onto world piste skis

Posted: Thu Jun 24, 2021 1:13 pm
by WorldMogul
I am looking to mount Rottefella Super Telemark bindings onto K2 world piste ski (pre-drilled with 4 hole inserts). I would like to use the inserts that are already there.

Does the Rottefella Super Telemark riser plate (link below), have a 4 hole pattern on the bottom to attach to the world piste skis?
https://www.telemark-pyrenees.com/rotte ... iser-plate

The rottefella cobra(link below) has a 4 hole pattern metal plate that fits the world piste skis? Would that same metal plate work with the super telemark riser?
https://rottefella.no/media/pdf-manuals ... bra-R8.pdf

Other advise on getting the Super Telemarks onto the world piste skis appreciated!
Thanks!

Re: mounting super telemark bindings onto world piste skis

Posted: Thu Jun 24, 2021 3:49 pm
by riel
WorldMogul wrote:
Thu Jun 24, 2021 1:13 pm
I am looking to mount Rottefella Super Telemark bindings onto K2 world piste ski (pre-drilled with 4 hole inserts). I would like to use the inserts that are already there.

Does the Rottefella Super Telemark riser plate (link below), have a 4 hole pattern on the bottom to attach to the world piste skis?
https://www.telemark-pyrenees.com/rotte ... iser-plate
The Voile riser plates attach to the ski with 4 screws, and then 3 screws are used to attach the bindings to the riser plates. That may be your best option. Those riser plates are available in several heights.

The Rottefella riser plates have 3 screws that go all the way from the binding, through the riser, into the ski. That doesn't sound like what you want.

Re: mounting super telemark bindings onto world piste skis

Posted: Thu Jun 24, 2021 9:38 pm
by Nick BC
Just a small point, if you use the Voile Traverse risers with a Super Telemark binding you will have to file/sand a small amount of plastic from the raised rear portion. The ST is a smidgen longer than the Voile HD Mountaineer. Not a big deal and I found this out when I mounted a Super Telemark cable binding on the Traverse shim.

Re: mounting super telemark bindings onto world piste skis

Posted: Thu Jun 24, 2021 11:45 pm
by WorldMogul
Ok thanks for the good info!! I ended up using the cobra mount plates which have the 4 hole pattern on bottom...the ST doesn't fit perfect onto it, but a bit of duct tape made it workable!

Re: mounting super telemark bindings onto world piste skis

Posted: Sun Jun 27, 2021 8:27 pm
by fgd135
WorldMogul wrote:
Thu Jun 24, 2021 11:45 pm
... but a bit of duct tape made it workable!
Red? Red Green?! Didn't know you were a tele skier!
fcac759c6ea5f012926e3bd9f6f1d6a0d946029b528bb22d401d6ac8057c91c0.jpg